"Push-Push": the Inflatable Boat Valves

• Available in 5 different models
• Made of strong non-hygroscopic POM: Push-Push valves are dimensionally stable because they do not absorb humidity, while valves made in Nylon may absorb water, causing them to deform and to leak!

• Designed with a rounded low profile and with the smallest overall dimensions
• The thick valve cage protects the internal components from impacts
• Double silicone seal, on the poppet and on the cap. Push-Push Valves are checked one by one during production for accidental leakage. PUSH-PUSH Valves do not leak even without the cap inserted!

• Standard colors: grey, white, black
• Personalised colors available on request (for large quantities only - quotation on request)

• Your own logo can be molded on the cap (for large quantities only - quotation on request)

The wide opening and our original "Push-Push System" make inflation and deflation faster and easier. Beware of imitations!

• Push the pin once to open the valve for deflating

• Push the pin once again to close the valve
• The valve must be in closed position for inflating

The pressure inside the inflatable boat can be measured with a special pressure gauge [SRSV106] [SRSV101]

"Push-Push" Valve [SRSV100]

The original Push-Push valve.

The valve requires 53 mm under the fabric.
Hole on the fabric ~ 38 mm Ø (~ 1 1/2 inch Ø).

"Push-Push" Short Valve [SRSV200]

Much shorter than the previous version. It is ideal for kayaks and smaller inflatable boats where less space is available under the fabric.
In spite of its reduced dimension, it is as strong as the larger model.

The valve requires 38 mm under the fabric.
Hole on the fabric ~ 38 mm Ø (~ 1 1/2 inch Ø).

"Push-Push" Short Valve with Invisible Strap [SRSV400]

With a further improvement in design, the cap strap is now positioned inside the body of the valve.
This new valve is ideal for kayaks and smaller inflatable boats, where a cumbersome valve would be inappropriate.
It has the same mechanical and structural characteristics as SRSV200.

The valve requires 38 mm under the fabric.
Hole on the fabric ~ 38 mm Ø (~ 1 1/2 inch Ø).

"Push-Push" Short Valve for High-Pressure Applications [SRSV300]

High-pressure valve: ideal as a floor valve in inflatable boats.
It has the same mechanical and structural characteristics as SRSV200.

The valve requires 38 mm under the fabric.
Hole on the fabric ~ 38 mm Ø (~ 1 1/2 inch Ø).

"Push-Push" Short Valve for High-Pressure Applications with Invisible Strap [SRSV500]

High-pressure valve.
With a further improvement in design, the cap strap is now positioned inside the body of the valve.
Ideal as a floor valve in inflatable boats.
It has the same mechanical and structural characteristics as SRSV200.

The valve requires 38 mm under the fabric.
Hole on the fabric ~ 38 mm Ø (~ 1 1/2 inch Ø).